Insulation
Rigid insulation and a cover board form the base and gives the adhesive a firm grip.
Flat Roofing
Rubber Roof Installation Palisades Park, NJ
A Palisades Park roofer who installs EPDM can put a new rubber roof on a flat or low slope section of almost any home, with as few seams as possible. Call (551) 348-3807 to reach a local roofer.
Rubber roofing usually means EPDM, though some people use the term for any single-ply membrane. EPDM is sold in wide rolls, typically 45 or 60 mil thick, and it stretches and recovers as the roof moves through hot and cold seasons. That flexibility is why it suits so many homes.
EPDM can be attached in three main ways. Adhered, fastened and ballasted systems each suit different buildings and wind conditions. On most homes, fully adhered EPDM is the usual choice because it handles wind well and stays smooth.
Then comes thickness and color. A 60 mil sheet is tougher than 45 mil for roofs that see foot traffic. White EPDM suits sunny roofs, and black suits cooler climates. The transition to a steeper roof or a wall is planned with the same care, since that is where low roofs most often leak.
Depending on what the roofer finds, rubber roof installation in Palisades Park, NJ can go hand in hand with rubber roof repair and flat roof installation.
Need rubber roof installation in Palisades Park? Call (551) 348-3807 to reach a nearby roofing contractor.
Call nowThe process
What happens during a rubber roof installation
A rubber roof is built in layers, with the seams and flashing as the critical details.
Prepare the deck
The roofer checks the deck for rot, gaps and loose sheets and confirms the roof has enough slope to drain. On a replacement, old layers come off first.
Install insulation
Polyiso insulation and a cover board create a flat, firm base for the rubber. Low spots can be corrected with tapered insulation.
Sheet layout
The membrane is unrolled, aligned and allowed to settle before bonding. Laps are arranged so water flows over them.
Apply adhesive
Contact adhesive goes on the board and the membrane, and once it is tacky, the sheet is laid down and brushed. The process repeats for the second half. Brooming from the middle outward pushes trapped air to the edges.
Seal the seams
Primer and seam tape join the sheets, with T-joints covered by extra patches. Exposed edges get lap sealant.
Flash the details
Flashing goes up walls and around curbs, with boots at pipes and new edge metal at the perimeter. The top edge is sealed and covered. Before the crew leaves, seams are probed for any loose spots.
What is included
What goes into a rubber roof
Rubber sheet
A 45 or 60 mil EPDM sheet is installed with as few seams as possible.
Tear-off
Old roofing is removed and the deck is repaired before new layers go down.
Edge metal
Termination bar, pipe boots and edge metal are installed for a finished roof.
Seam tape
Every seam gets primer and tape and is checked before closeout.
Related service
EPDM Roof Installation Palisades Park, NJ
EPDM roof installation is straightforward in concept and demanding in the details. A flat, dry base, properly timed adhesive and carefully primed seams are what make EPDM last. Weather matters too, since adhesives and primers need dry conditions. Different adhesives may be used in the field and at the flashings, each matched to the job it does.
A good Palisades Park installer also plans for movement. Perimeter securement and proper flashing help prevent the shrinkage problems older rubber roofs show. Ask about edge securement before work starts.
Local help
Rubber Roof Installation Near Me
Around Palisades Park, homeowners often choose EPDM for flat roof sections because it is durable and easy to repair. Homes in Palisades Park and nearby places including Leonia, Ridgefield Park, Ridgefield and Fort Lee benefit from rubber roofing because it flexes with the seasons, so installation details matter as much as the material.
For rubber roof installation in Palisades Park, NJ or nearby towns like Leonia, Ridgefield Park, Ridgefield and Fort Lee, call (551) 348-3807 to reach a roofer who covers your street.
What the local climate does to a roof
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Palisades Park is busiest after a hard winter and before the next one.
Why call
Why not wait
Drier ceilings
Small roof problems caught early usually stay small repairs.
Familiar with local homes
Roofers in Palisades Park know the roof types and weather wear common in local homes.
Straight answers
Ask your questions before you agree to anything.
Rubber Roof Installation questions
Is it possible to install EPDM over the old roof?
Recovering depends on the condition of the old roof. Codes generally allow one recover over a dry, sound roof. Otherwise, a tear-off is needed. The roofer tests the old roof for moisture before recommending a recover.
What color EPDM is best?
Black and white each have their place. White helps in sunny climates, and black is common where winters are long. Talk through the choice with a roofer.
What is the lifespan of a new EPDM roof?
EPDM can last 25 years or longer. Good seams, drainage and occasional checks make the difference. Small repairs are easy to make.
Which EPDM thickness should I choose?
The common choices are 45 mil and 60 mil. The thicker sheet holds up better to traffic and weather. Heavy duty options exist too.
Is a rubber roof the same as TPO?
EPDM is synthetic rubber, while TPO is a thermoplastic membrane. Black EPDM is taped and stretchy, and white TPO is welded and reflective. Both are common on flat roofs.
More questions? Call (551) 348-3807
Often needed together
Rubber Roof Repair
Fixing open seams, punctures, shrinkage and split flashing on EPDM rubber roofs, never with tar or asphalt cement that ruins the rubber.
Learn moreFlat Roof Installation
Installing TPO, PVC, EPDM or modified bitumen roofs on additions, garages, porches and flat-roof homes, planned around how the roof will be used.
Learn moreTPO Roofing
White, heat-welded TPO single-ply roofing for low-slope homes and buildings, sized to the deck, the drains and the way the roof is used.
Learn moreFlat Roof Replacement
Tearing off or recovering a worn flat roof and installing a new membrane, insulation and edge metal, with tapered insulation where water used to sit.
Learn more
Looking for something else?
See all roofing servicesTalk to a Palisades Park roofer about rubber roof installation
Call (551) 348-3807 for a local roofer in Palisades Park and nearby towns.