Roof vents
An exhaust system sized for the attic for a drier attic all year.
Roof Replacement
Roof Installation Palisades Park, NJ
A roofer in Palisades Park can install a new roof in the proper sequence: drip edge, ice and water shield, underlayment, starter strip, flashing, vents and then the roofing itself, because the details at edges, walls and valleys decide whether it leaks. Dial (551) 348-3807 to talk with a local roofer about installation.
When a fairly new roof leaks, the cause is usually how it was installed rather than what it was made of. Nails driven above the reinforced strip, flashing left out at a sidewall and short valleys are the kind of mistakes that show up within a few seasons. None of these are visible from the ground once the job is done.
Choosing the material comes first. Most homes get dimensional asphalt shingles, but metal panels, stone coated steel, tile and slate are all options, and each has its own installation rules. Roof pitch matters too, since standard shingles need enough slope to shed water and very low pitches call for a membrane instead.
It helps to bring a few details to the first conversation. Know whether this is a replacement on an existing home, a new addition or a brand new house, what roofing you are considering and whether the attic has soffit vents.
Depending on what the roofer finds, roof installation in Palisades Park, NJ can go hand in hand with roof replacement and shingle roof installation.
Need roof installation in Palisades Park? Call (551) 348-3807 to talk to a local roofer.
Call nowThe process
How roof installation works
Each layer protects the one under it, so the order is not optional.
Check the sheathing
Installation starts on a sound, dry deck, so damaged sheathing is cut out and replaced first. If the job is an overlay instead, the existing roof has to be flat enough to accept a new layer.
Install the ice barrier
Drip edge goes on at the eaves, ice and water shield is rolled out along the eaves and in the valleys, and drip edge is then added along the rakes over the underlayment. This is the part of the roof most likely to see ice and backed-up water.
Underlayment install
Underlayment rolls go on from the eaves up, with laps that shed water down the roof. Synthetic is lighter, tears less and stays put better than felt if it rains mid-job.
Set the flashing
Flashing goes in as the roofing goes up: step pieces at walls, a kickout at the bottom edge and boots on every pipe. Sealant is a backup, not the flashing itself.
Put down the roofing
A starter strip goes along the eaves and rakes, then shingles are laid in straight courses and nailed in the reinforced nail zone, with four or six nails each as the maker specifies. Valleys are finished as open metal, closed cut or woven, depending on the material and the plan.
Ridge ventilation
The crew opens a slot at the ridge for a ridge vent, or installs box vents, and finishes with cap shingles. Without enough soffit intake, a ridge vent cannot do its job.
What is included
Components of the installation
Metal edging
Metal edges around the whole roof keeps water off the fascia boards.
Ice barrier
Ice and water shield at the eaves and valleys, with underlayment over the rest of the deck backs up the roofing in wind-driven rain.
The roofing
The finished roofing, installed to the maker's nailing and fastening pattern from the eaves up to the peak.
Flashing
New flashing at every wall, chimney and vent pipe seals the places where the roof meets something else.
Related service
New Roof Installation Palisades Park, NJ
Whether the roof is going on a new house, an addition or a stripped deck, the installation steps are largely the same. Tie-ins between new and old roofs are a common leak point, so they need full ice barrier and careful flashing. Ask whether the new section will match the existing roofing or whether the whole roof should be redone.
Manufacturers publish exact steps for their products, and local code usually requires following them. Good questions for a Palisades Park roofing contractor include nail count, underlayment type and the ventilation plan. Vague answers about the hidden layers are worth noticing.
Related service
Roof Overlay Palisades Park, NJ
With an overlay, sometimes called a layover or recover, the new roofing goes on top of the existing shingles. Most codes allow no more than two layers, which means an overlay is ruled out if there are already two, or if the deck is soft or the old shingles are buckled. The appeal is less labor, less debris and a shorter job.
An overlay comes with downsides worth weighing. Nobody can see or repair the decking, the old flashing tends to stay in place, the extra weight sits on the framing, and bumps in the old roof can telegraph through the new shingles. If you do go that route, make sure the scope still includes new flashing, drip edge and pipe boots.
Local help
Roof Installation Near Me
Around Palisades Park, roof installation work covers older houses getting their second or third roof and newer homes adding on. Across Palisades Park and nearby places including Leonia, Ridgefield Park, Ridgefield and Fort Lee, storms take the biggest toll on roofs that were installed with shortcuts, which is why the installation plan deserves as much attention as the material.
For roof installation in Palisades Park, NJ or nearby towns like Leonia, Ridgefield Park, Ridgefield and Fort Lee, call (551) 348-3807 to reach a roofer who covers your street.
What the local climate does to a roof
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. Most homeowners in Palisades Park, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why fix it now
Smaller repairs
Small roof problems caught early usually stay small repairs.
Roofers who know Palisades Park
Roofers in Palisades Park know the roof types and weather wear common in local homes.
Know what happens next
Ask your questions before you agree to anything.
Roof Installation FAQ
What goes under a new roof?
A new roof should have drip edge, ice barrier along the eaves and valleys and synthetic or felt underlayment everywhere else. Starter shingles and new flashing at walls and pipes belong in the scope too.
How long does it take to install a new roof?
For an average house, plan on one to three days. Steep pitches, many valleys and dormers, extra deck repair or a material like tile or standing seam metal take longer.
Can a roof be installed in cold weather?
Winter installation is possible, with a few precautions. Crews keep shingles warm and may hand seal them, since the strips will not stick until the sun warms them. The deck has to be dry and free of frost.
Which roofing material is best for my house?
That depends on the house, the slope of the roof and your priorities. Architectural asphalt shingles suit most homes, metal lasts longer and sheds snow well, and tile or slate need framing that can carry their weight. A roofer can walk through the options for your specific roof.
Is a permit needed to install a new roof?
Requirements depend on where you live, but a permit is common for a full roof. Ask who will apply for the permit and whether an inspection is required.
More questions? Call (551) 348-3807
Other services that may help
Roof Replacement
Replacing an aging roof with new underlayment, flashing, vents and roofing, so the house is dry for decades instead of seasons.
Learn moreShingle Roof Installation
New shingle roofs built layer by layer on a sound deck, so the roof sheds water and handles wind from day one.
Learn moreMetal Roof Installation
New metal roofs in standing seam, exposed fastener, metal shingle and stone coated steel, for homes, garages and outbuildings.
Learn moreNew Construction Roofing
New construction roofs coordinated with the builder's schedule, planned with ventilation and penetrations in mind.
Learn more
Looking for something else?
See all roofing servicesTalk to a Palisades Park roofer about roof installation
Call (551) 348-3807 to talk to a roofer serving Palisades Park, NJ.