Surface prep
A full wash and removal of loose material so the coating bonds properly.
A roofer in Palisades Park can apply a liquid roof coating, usually silicone or acrylic, over a flat, low-slope or metal roof that is weathered but still dry and structurally sound, and a moisture check comes first, because coating over wet insulation traps the problem. Call (551) 348-3807 to reach a local roofer.
Think of a coating as a new, seamless surface layer fused to an aging roof. The coating covers weathered surfaces, seams and fastener heads and blocks the sunlight that ages roofing materials. White coatings reflect much of the sun's heat, so the roof surface runs cooler in summer.
Coatings are made mainly for flat roofs, low-slope membranes and metal panels. Common substrates include rubber and TPO membranes, torch-down or self-adhered mod bit, built-up roofs, foam and metal panels. Most roofers do not recommend coating asphalt shingles, since it can trap moisture and may conflict with the shingle maker's terms.
The biggest mistake is coating a roof that is wet inside. Wet insulation under a coating cannot dry out, and it keeps rotting the deck below. Expect the roofer to test for moisture before recommending a coating at all.
Depending on what the roofer finds, roof coating in Palisades Park, NJ can go hand in hand with flat roof repair and metal roof coating.
Looking for Palisades Park roof coating? Call (551) 348-3807 to talk to a local roofer.
Call nowMost of a coating job is preparation, not spraying.
A moisture survey finds any wet insulation or decking before a coating is considered. Any soaked areas must be removed and replaced first.
A thorough wash strips away dirt, algae and chalky residue. Rust on metal is wire-brushed and primed.
Open seams, blisters, splits and failed flashing are repaired, and exposed fasteners on metal are tightened or replaced with oversized screws. A coating hides the surface, so anything left unrepaired stays hidden.
Depending on the roof material and the coating, a primer may be needed for adhesion, especially on EPDM, TPO and rusted metal. Adhesion problems are hard to fix later.
The crew builds up the coating to the specified thickness, measured in mils, across the whole roof. Rain or dew before curing can wash out acrylic, so timing is important.
A full wash and removal of loose material so the coating bonds properly.
A seamless coating sprayed or rolled over the roof with detail coats at seams and penetrations.
Seams, blisters, punctures, flashing and fasteners repaired before the coating goes on.
A check for wet insulation or decking before any coating is recommended.
Where a coating adds a protective layer, roof restoration includes all the repairs needed to make the existing roof sound again. Expect it to include repairs to seams, flashing, drains and fasteners, followed by a complete coating. It is a way to extend roof life while keeping the old roof out of the landfill.
Timing is everything with restoration. Roofs that still feel firm underfoot and test mostly dry are the ones that restore well. Ask the roofer in Palisades Park to show you the moisture results and explain why restoration or replacement fits your roof.
Low-slope roofs are where coatings make the biggest difference. Silicone handles ponding water well and stays flexible, acrylic is reflective and easy to recoat but should not sit under standing water, and polyurethane is tough against foot traffic and impact. Each roof type, from rubber to modified bitumen, has products and primers made for it.
Before coating a flat roof, the drains and scuppers deserve a close look. Clogged drains, blocked scuppers and low spots that hold water for days should be addressed, since standing water shortens the life of most coatings. An annual look, especially at seams and drains, helps catch wear early.
Around Palisades Park, coatings are usually applied to flat porch and garage roofs, low-slope additions and metal roofs. Across Palisades Park and nearby places including Leonia, Ridgefield Park, Ridgefield and Fort Lee, sun and storms wear down low-slope roofs fastest, which is where coatings help most, provided the roofer confirms there is no trapped moisture.
Need roof coating around Palisades Park? Call (551) 348-3807 for a Palisades Park roofer who serves the towns around it too.
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. Most homeowners in Palisades Park, NJ have the roof checked in the fall and again after the snow melts.
Small roof problems caught early usually stay small repairs.
Local roofers see the same roofs and storm damage across Palisades Park and nearby towns.
Ask your questions before you agree to anything.
More questions? Call (551) 348-3807
Repairs for leaking flat roofs, from punctures and seams to clogged drains and wet insulation, with the patch made from material that bonds to what is there.
Learn moreCleaning, priming and coating a worn metal roof to seal seams and fasteners and stop surface rust, as a step between repair and replacement.
Learn moreCoating systems that seal and reflect sun on commercial roofs, to extend roof life without a tear-off.
Learn moreRoutine roof care: clearing valleys, replacing worn pipe boots, sealing exposed nails and resetting lifted shingles, so the roof reaches the end of its expected life.
Learn moreLooking for something else?
See all roofing servicesCall (551) 348-3807 to talk to a roofer serving Palisades Park, NJ.